Frost line depth by ZIP code and state

How deep footings, deck posts and water lines have to go where you live, from each state's building code. Enter a ZIP code, or pick your state on the map.

Turn the answer into a reminder. I am Home builds your home's seasonal plan from your ZIP in about a minute: the jobs that matter this season, each with a how-to. Free, every feature.
Get my plan

Frost line depth map

None Up to 12″ 13–24″ 25–36″ 37–48″ Over 48″ The typical building-code frost depth in each state. * = it varies by county or town; tap a state for its numbers.

Frost line depth by state

The number each state's residential building code uses, or, where the state leaves it to local building departments, the range they publish. Each state's page has the county table or the local values, the code section, and the source.

StateFrost depthSet by
Alabama 12 inches Set locally
Alaska 42 to 120 inches, usually 42 Set locally
Arizona 12 to 30 inches, usually 12 Set locally
Arkansas 12 to 24 inches, usually 12 Set locally
California 12 to 24 inches, usually 12 Set locally
Colorado 30 to 48 inches, usually 36 Set locally
Connecticut 42 inches Statewide
Delaware 24 to 32 inches, usually 32 Set locally
District of Columbia 30 inches Statewide
Florida None (12″ footing minimum) No frost depth
Georgia 12 inches Set locally
Hawaii None (12″ footing minimum) No frost depth
Idaho 24 inches Set locally
Illinois 36 to 42 inches, usually 42 Set locally
Indiana 24 to 36 inches By county
Iowa 42 inches Set locally
Kansas 24 to 36 inches, usually 36 Set locally
Kentucky 24 to 33 inches By zone
Louisiana None (12″ footing minimum) No frost depth
Maine 48 to 60 inches, usually 48 Set locally
Maryland 18 to 36 inches, usually 30 Set locally
Massachusetts 48 inches Statewide
Michigan 42 inches Statewide
Minnesota 42 to 60 inches By zone
Mississippi None (12″ footing minimum) No frost depth
Missouri 18 to 36 inches, usually 30 Set locally
Montana 36 to 48 inches, usually 42 Set locally
Nebraska 36 to 42 inches, usually 42 Set locally
Nevada 12 to 36 inches, usually 12 Set locally
New Hampshire 48 inches Set locally
New Jersey 30 to 36 inches By zone
New Mexico 16 to 36 inches, usually 16 Set locally
New York 42 to 48 inches, usually 48 Set locally
North Carolina 12 inches Statewide
North Dakota 48 to 54 inches, usually 54 Set locally
Ohio 30 to 42 inches, usually 36 Set locally
Oklahoma 18 inches Set locally
Oregon 12 to 24 inches By county
Pennsylvania 30 to 48 inches, usually 36 Set locally
Rhode Island 40 inches Statewide
South Carolina 12 inches Set locally
South Dakota 42 inches Set locally
Tennessee 12 inches Set locally
Texas 12 to 24 inches, usually 12 Set locally
Utah 30 to 36 inches, usually 30 Set locally
Vermont 60 inches Set locally
Virginia 12 to 24 inches, usually 24 Set locally
Washington 12 to 24 inches, usually 12 Set locally
West Virginia 24 to 32 inches, usually 30 Set locally
Wisconsin 48 inches Statewide
Wyoming 34 to 54 inches, usually 36 Set locally

What the frost line is

The frost line, or frost depth, is how far down the ground freezes in a hard winter. Wet soil expands as it freezes and lifts anything resting in it, then lets it drop when it thaws. That's frost heave, and it's why a deck post set too shallow rises a little every winter, a fence leans, and concrete steps crack away from the house.

So building codes require footings to sit below it. The model code most states adopt, the International Residential Code, says footings must reach the frost line set by the local building official (section R403.1.4.1), and never sit less than 12 inches below undisturbed ground anywhere (R403.1.4). Each state, county or city fills in the number in its climatic and geographic design-criteria table (IRC Table R301.2, numbered R301.2(1) before the 2021 edition).

Why online "frost depth maps" don't match your building department

The maps that show deep frost across the whole northern half of the country usually come from research data: how deep the ground actually froze, or a 100-year design figure for unheated, snow-free ground. A building code number is a rule, set once for a whole town or county and often rounded to a safe, simple figure. The two can differ by a foot or more, and only the code number matters for a permit. That's why this page uses the code values and links to where each one comes from.

What has to go below it

  • Deck, porch and addition footings. The bottom of the footing, measured from finished grade. The inspector checks the hole before the concrete goes in.
  • Garages and other foundations. The model code exempts small detached sheds and garages (light-frame, up to 600 square feet, eaves 10 feet or lower) and decks not attached to the house, but not every town adopts those exceptions.
  • Water and sewer lines. Below the frost line at least. Many water utilities set a deeper burial depth for the service line from the street.
  • Fence posts. No code requires it for an ordinary fence, but posts set to the frost depth, with gravel at the bottom, don't heave and lean.
Before you dig, call 811. It's free, most states require it, and the utilities come and mark their buried lines within a few days. Then check your building department's deck or footing handout. Some towns ask for more than the state minimum, and a few allow a footing to stop at solid rock.

Can a footing be shallower?

Yes, with a frost-protected shallow foundation (FPSF): rigid foam insulation laid around and out from the footing keeps the ground under it from freezing, so the footing can be as shallow as about 12 to 16 inches in most of the country. It's in the model code (IRC R403.3) and common in Scandinavia, but it has to be designed for your climate, and it's rare for decks. Ask your building department before you plan on it.

Sources

Frequently asked

What is the frost line?

The depth to which the ground freezes in a hard winter where you live. Wet soil expands as it freezes and lifts anything resting in it, so building codes require footings, and in practice water lines, to go below it.

How do I find the frost line depth for my address?

Enter your ZIP code in the lookup on this page: it gives the building-code number for your county where your state's code sets one, or your state's number or range. Your city or county building department has the final word; most publish it in a deck or footing handout.

Why does my building department's number differ from frost depth maps online?

Most online maps show research data, such as how deep the ground has actually frozen or a 100-year design value for bare ground. The code number is a rule set for a whole town or county and is the one an inspector checks. They can differ by a foot or more.

Do fence posts have to go below the frost line?

No building code requires it for an ordinary fence, but posts set shallower than the frost depth tend to heave and lean after a few winters. Setting them to the frost depth, with a few inches of gravel under the post, keeps them straight. Tall privacy fences and pool barriers can need a permit with their own rules.

Do deck footings always have to go below the frost line?

Footings for a deck attached to the house do. The model code (IRC R403.1.4.1) exempts decks that aren't supported by the house, and small detached sheds, but many towns don't adopt those exceptions, so ask before you rely on one.

What is a frost-protected shallow foundation?

A footing protected by rigid foam insulation laid around and out from it, which keeps the ground below from freezing. It lets the footing sit much shallower than the frost line. It's in the model code (IRC R403.3) but has to be designed for your climate, so check with your building department first.

Share this article
Link copied

Read more about it

More home calculators